Synfocom Systems LLP

The GPON module allows any RouterBOARD device to be used for Fiber to Home installations without any special modems or software. A plug and play solution means you simply plug it into your device, and no special configuration is needed. It is supported by all our SFP products, with any RouterOS version - all configuration will be done on the ISP side.The GPON ONU integrates GPON OMCI Stack and is fully compliant with ITU-T G.984 standards. 

• Simplex SC Connector, Integrated Diplexer Transceiver
• SFP MSA, digital diagnostics SFF-8472 Compliant
• Compliant to FSAN G.984.5 Specifications
• 1244 Mbps Tx, 2488 Mbps Rx Asymmetric Data Rate
• Operating case temperature: 0~70°C
• Subscriber location identifier (SLID)
• PON Link Status notification
• Dying Gasp notification 
• Supports Time of Day and 1PPS interface
• Response the TX power shut-down command from OLT when OLT detect anomaly
• TC Layer GEM encapsulation mode
• OMCI support per ITU-T G.988
• 32 dB link budget; Class C+, 20 km reach
• Compliant to IEC-60825 Class 1 laser diode
• RoHS compliant
• Internal Calibration

It designed expressly for high-speed communication applications that require rates up to 10.7Gbps,it designed to be compliant with SFF-8472 and SFP+ MSA. The module data link up to 20km in 9/125um single-mode fiber. The optical output can be disabled by an LVTTL logic high-level input of Tx Disable. Tx Fault is provided to indicate the degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner

• SFP MSA package with duplex LC connector
• Digital Diagnostic Monitor Interface
• 10Gb/s serial optical interface
• Up to 20km distance
• Compliant with SFP+ MSA
• High transmission margin
• SFP mechanical interface

It designed expressly for high-speed communication applications that require rates up to 10.7Gbps,it designed to be compliant with SFF-8472 and SFP+ MSA. The module data link up to 40km in 9/125um single-mode fiber. The optical output can be disabled by an LVTTL logic high-level input of Tx Disable. Tx Fault is provided to indicate the degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner

• SFP MSA package with duplex LC connector
• Digital Diagnostic Monitor Interface
• 10Gb/s serial optical interface
• Up to 40km distance
• Compliant with SFP+ MSA
• High transmission margin
• SFP mechanical interface

S+85DLC03D is a 10G SFP+ transceiver with a LC connector, 850nm, for up to 300 meter Multi Mode fiber connections Units are tested and compatible with CCR1036-8G-2S+ and CCR1036-8G-2S+EM. Units are compatible with non-MikroTik SFP devices as well.

SFP 1.25G Single Fiber 20Kms SC transceivers are high performance, cost-effective modules supporting dual data-rate of 1.25Gbps/1.0625Gbps and 20km transmission distance with SMF. The transceiver consists of three sections: an FP laser transmitter, a PIN photodiode integrated with a trans-impedance preamplifier (TIA), and an MCU control unit. All modules satisfy class I laser safety requirements. The transceivers are compatible with SFP Multi-Source Agreement (MSA) and SFF-8472. Dual data-rate of 1.25Gbps/1.063Gbps operation 1310nm FP laser and PIN photodetector for 20km transmission Compliant with SFP MSA and SFF-8472 with single SC receptacle

• Dual data-rate of 1.25Gbps/1.063Gbps operation
• 1310nm FP laser and PIN photodetector for 20km transmission
• Compliant with SFP MSA and SFF-8472 with single LC receptacle
• Digital Diagnostic Monitoring
• Internal Calibration or External Calibration
• Compatible with SONET OC-24-LR-1
• Compatible with RoHS

The SFP-BIDI transceivers are high performance, cost effective modules supporting dual data-rate of 1.25Gbps/1.0625Gbps and 20km transmission distance with SMF. The transceiver consists of three sections: a FP laser transmitter, a PIN photodiode integrated with a trans-impedance preamplifier (TIA) and MCU control unit. All modules satisfy class I laser safety requirements. The transceivers are compatible with SFP Multi-Source Agreement (MSA) and SFF-8472. Dual data-rate of 1.25Gbps/1.063Gbps operation 1310nm FP laser and PIN photo detector for 20km transmission

• Dual data-rate of 1.25Gbps/1.063Gbps operation 1310nm FP laser and PIN photo detector for 20km transmission
• Compliant with SFP MSA and SFF-8472 with single LC receptacle Digital Diagnostic Monitoring:
• Internal Calibration or External Calibration Compatible with SONET OC-24-LR-1
• Compatible with RoHS +3.3V single power supply Operating temperature: Standard : -5 to +70 degree Industrial : -40 to +85 degree

Additional Information:

• Item Code: UF-MM-1G

SFP 1.25G Single Fiber 20Kms SC transceivers are high performance, cost-effective modules supporting dual data-rate of 1.25Gbps/1.0625Gbps and 20km transmission distance with SMF. The transceiver consists of three sections: an FP laser transmitter, a PIN photodiode integrated with a trans-impedance preamplifier (TIA), and an MCU control unit. All modules satisfy class I laser safety requirements. The transceivers are compatible with SFP Multi-Source Agreement (MSA) and SFF-8472. Dual data-rate of 1.25Gbps/1.063Gbps operation 1550nm FP laser and PIN photodetector for 20km transmission Compliant with SFP MSA and SFF-8472 with single SC receptacle

• Dual data-rate of 1.25Gbps/1.063Gbps operation
• 1550nm FP laser and PIN photodetector for 20km transmission
• Compliant with SFP MSA and SFF-8472 with single LC receptacle
• Digital Diagnostic Monitoring
• Internal Calibration or External Calibration
• Compatible with SONET OC-24-LR-1
• Compatible with RoHS

SFP 1.25G Single Fiber 40Kms LC transceivers are high performance, cost-effective modules supporting dual data-rate of 1.25Gbps/1.0625Gbps and 40km transmission distance with SMF. The transceiver consists of three sections: an FP laser transmitter, a PIN photodiode integrated with a trans-impedance preamplifier (TIA), and an MCU control unit. All modules satisfy class I laser safety requirements. The transceivers are compatible with SFP Multi-Source Agreement (MSA) and SFF-8472. Dual data-rate of 1.25Gbps/1.063Gbps operation 1310nm FP laser and PIN photodetector for 20km transmission Compliant with SFP MSA and SFF-8472 with single LC receptacle

• Dual data-rate of 1.25Gbps/1.063Gbps operation
• 1310nm FP laser and PIN photodetector for 40km transmission
• Compliant with SFP MSA and SFF-8472 with single LC receptacle
• Digital Diagnostic Monitoring
• Internal Calibration or External Calibration
• Compatible with SONET OC-24-LR-1
• Compatible with RoHS

S-35/53LC20D is a pair of SFP transceivers, the S-35LC20D is a 1.25G Single Mode optical SFP module with a LC connector, T1310nm/R1550nm, which works for connections up to 20km and supports DDM. The S-53LC20D is a 1.25G Single Mode optical SFP transceiver with an LC connector,T1550nm/R1310nm, which works for connections up to 20km and supports DDM.  Units are tested and compatible with RB260GS, RB2011LS, RB2011LS-IN, RB2011UAS-IN, RB2011UAS-RM, RB2011UAS-2HnD, RB2011UAS-2HnD-IN CCR1036-12G-4S. Units are compatible with non-MikroTik SFP devices as well.